Time delay from 1-30 minutes, in minute increments
Setting retained even after loss of power
Can power fans, motors, pumps, contactors and inductive loads
Suits Clipsal Saturn and Saturn Zen style wall plates
The S-Click HNS446TM is a 3-wire minute timer switch that is ideal for fans, motors and commercial lighting. Time delay can be set in minute increments from 1-30 minutes-perfect for lights or appliances that are only required for relatively short periods. Alternatively, this 2-in-1 unit also allows for regular operation of lights and appliances; a sustained two-second press turns power on with no time out and can be manually turned off with a quick tap.
Our minute timer switch is ideal for heat lamps, spa air pumps, exhaust fans and other fans. A blue LED indicates device status and gives an expiry warning within the last 10 seconds before program time-out. The timer settings are retained even after loss of power and can be configured to power up on or off after loss of mains power.
Programming your chosen off time couldn't be simpler. A sustained 10 second press of the button enters programming mode. Just tap the button once for each minute of run time you require, up to 30 minutes. Programming mode expires 10 seconds after the last tap, and the unit then commits your settings to memory. If you happen to press the button more than 30 times, the maximum run time of 30 minutes will be stored.
Applications and Compatibility
The HNS446TM is compatible with a wide range of load types including wire wound transformers & fan motors. Suggested uses include heat lamps, fans, exhaust fans and spa air pumps.
Motion Detector mode delivers perfect operation with the S-Click HNS050MD & HNS060MD Motion Detectors. Suits Clipsal Saturn and Saturn Zen style wall plates.
Multi-way Switching capable with the S-Click HNS026RB Remote Button.
Operating Voltage: 230-240Va.c. 50Hz
Operating Temperature: 0 to +50 degrees Celsius.
Certified Standards: CISPR15, AS/NZS3100, AS/NZS60669.2.1
Maximum Load: 1200W/500VA
Maximum Current Capacity: 5A
Terminals: Screw Terminals suit 0.5mm2 to 1.5mm2 stranded (bootlace terminal recommended)
Note: Operation at temperature, voltage or load outside of the specifications may cause permanent damage to the unit.
The HNS446TM is to be installed as part of a fixed wire electrical installation. By law such installations must be made by an electrical contractor or similarly qualified person. For operating instructions and important safety warnings, refer to the User Manual for more information.
|Max Current (A):||5|
|Max Time Out (hrs):||0.5|
|Max Load (VA):||500|
|Timer Range:||1 ~ 60 minutes|
|Number of Wires:||3|
Your ordered quantity for this item is more than what we have in stock.
Please contact us to know more about this item's availability or possible restock dates.