Time delay from 1-59 minutes, in minute increments
Setting retained even after loss of power
Can be retrofitted to most installed lights
The S-Click HNS410TM is a 2-in-1 lighting timer switch that automatically turns lights off after a pre-determined time. Time delay can be set in minute increments from 1-60 minutes - perfect for areas that are frequently occupied for relatively short periods. Supporting both timer and non-timer functions, this unit also allows for lights to be manually turned off with a quick tap.
Our minute timer switch is ideal for domestic use and can be retrofitted to most installed lights. A blue LED indicates device status and gives an expiry warning within the last 10 seconds before the lights time-out. The timer settings are retained even after loss of power and can be configured to power up on or off after loss of mains power.
Programming your chosen off time couldn't be simpler. A sustained 10 second press of the button enters programming mode. Just tap the button once for each minute of run time you require, up to 60 minutes. Programming mode expires 10 seconds after the last tap, and the unit then commits your settings to memory. If you happen to press the button more than 60 times, the maximum run time of 60 minutes will be stored.
Applications and Compatibility
The HNS410TM is perfect for lighting in areas such as hallways, garages, laundries and wardrobes. All require adequate lighting but are generally not occupied for extended periods. Using a minute timer switch in these areas prevents the excess energy consumption caused by leaving lights on accidently.
The HNS410TM is compatible with HPM and Clipsal Style wall plates. Multi-way switching capable using 240V normally open momentary switches-refer to the product datasheet for more information.
Not suitable for fans, motors or iron core ballasts.
Operating Voltage: 230 - 240V a.c. 50Hz
Operating Temperature: 0 to +50 degrees Celsius
Compliance Standard: CISPR15, AS/NZS 3100, AS/NZS 60669.2.1
Maximum Load: 400VA
Minimum Load: 10VA
Maximum Current capacity: 1.7A
Terminals: Screw Terminals suit 0.5mm2 to 1.5mm2 stranded (bootlace terminal recommended)
Note: Operation at temperature, voltage or load outside of the specifications may cause permanent damage to the unit.
The HNS410TM is to be installed as part of a fixed wire electrical installation. By law, such installations must be made by an electrical contractor or similarly qualified person. For operating instructions and important safety warnings, refer to the product User Manual.
|Max Current (A):||1.7|
|Max Time Out (hrs):||0.5|
|Max Load (VA):||400|
|Min Load (VA):||10|
|Timer Range:||1 ~ 60 minutes|
|Number of Wires:||2|
Your ordered quantity for this item is more than what we have in stock.
Please contact us to know more about this item's availability or possible restock dates.